Page 1 of 1
[FIXED] 1328.11 Targeting Vectors do not display in "selected Unit" Mode
Posted: Sat Nov 04, 2023 11:51 pm
by boogabooga
Targeting Vectors do not display in "selected Unit" Mode under the Map Settings. They do work in "All" mode. This is in ALL scenarios, so I'm not going to post one.
Re: 1328.11 Targeting Vectors do not display in "selected Unit" Mode
Posted: Sun Nov 05, 2023 11:58 am
by zacklaws
I'm also seeing the same issue as well in 1328.11.
Also I'm seeing a similar issue with "Illumination Vectors", regardless of the setting "None", "Selected" or "All", they are being displayed for "All" permanently even when "None" is selected. Sometimes I can get "Selected" displaying and no others showing, but if I then select "All", then all display and I cannot get it to go back to just being "Selected" showing.
Re: 1328.11 Targeting Vectors do not display in "selected Unit" Mode
Posted: Wed Nov 08, 2023 8:22 pm
by Raptorx7_slith
Thanks for the report, logged as 0015396
Re: 1328.11 Targeting Vectors do not display in "selected Unit" Mode
Posted: Wed Nov 08, 2023 8:55 pm
by zacklaws
I may actually be wrong about the illumination vectors, I'm not seeing an issue today with them but definitely still an issue with targeting vectors.
Re: 1328.11 Targeting Vectors do not display in "selected Unit" Mode
Posted: Wed Jan 03, 2024 1:50 pm
by Dimitris
Illumination vectors issue not reproduced, targeting vectors issue confirmed and fixed for the next release.