Moving Objectives???

[Werewolf13]

The manual says that you can both move and adust the size of an objective when using the battle generator using drag and drop.

I can't. Tried everything I can think of to grab an objective and move it. Same with the size (though you can use the objective radius + - buttons to make one smaller or larger - in rather large increments though).

Is the manual wrong or do I just not get it? Hopefully I just don't get it because I find the default locations chosen by the AI to be in most cases - well - kind'a strange.

[Issue8]

In the battle generator screen if you click on an objective, it will disappear and then re-appear in a new location that you click. This way you can change the objective locations.

[Werewolf13]

ORIGINAL: Issue8

In the battle generator screen if you click on an objective, it will disappear and then re-appear in a new location that you click. This way you can change the objective locations.

Ahhhh...
Nice. Thanks.

[Issue8]

Another thing: you can adjust the size of the deployment areas if you click inside the green or red areas and slide the mouse, making the deployment areas wider or more narrow.

[zacklaws]

You also cannot place an objective over a feature containing water ie a bridge. So if you cannot place an objective where you want one especially if you want a scenario defending a bridge, it may be because there is a water feature in that location which will not allow you to do it..