Matrix Games Forums

I agree the flag looks better on the mast. Another fine piece of work.

Italian Armoured cruiser Pisa class[;)]

Italian Pisa class cruiser but to scale this time[;)]



General characteristics
Class and type: Pisa-class armored cruiser
Displacement: 9,832 metric tons (9,677 long tons), standard.
10,401 metric tons (10,237 long tons), full
Length: 426 ft 6 in (130.00 m)
461 ft (140.5 m) (oa)
Beam: 68 ft 11 in (21.01 m)
Draft: 22 ft 8 in (6.91 m)
Propulsion: 2 x propeller shafts
2 x vertical triple-expansion steam engines
22 x coal-fired Belleville boilers
20,260 indicated horsepower (15,110 kW)
Speed: 23.6 knots (43.7 km/h)
Endurance: 2,500 nautical miles @ 12 knots (4,600 km @ 22 km/h)
1,400 nautical miles @ 21 knots (2,600 km @ 39 km/h)
Armament: 4 × 10-inch (254 mm)/45 guns (2 × 2)
8 × 7.5 in (190 mm)/45 guns (4 × 2)
16 × 3 in (76 mm)/40 guns
8 × 47 mm (1.9 in)/50 guns
4 × machine guns
3 × 450 mm (17.7 in) torpedo tubes

Armor: side: 200 mm (7.9 in)
deck: 130 mm (5.1 in)
conning tower: 180 mm (7.1 in)
10 in (25 cm) gun turrets: 160 mm (6.3 in)
7.5 in (19 cm) gun turrets: 130 mm

Italian San Giorgio class Armoured cruiser[;)]

Hey guys do you prefer the ship art to be to scale or do you want them larger so that you can see more detail?[&:]

This art work is slightly larger than she should be,but personally I prefer to make out more detail.[;)]

Graham I like more details myself.

I agree with Aces, I prefer the details over scale. Besides, if they were all to scale then the destroyers would be about the size of a gnat!

Ok I will make them large enough to see individual detail on the ships,I'm sure the Italian Armoured cruisers are 130 pixels in lenght,so I will use a sliding scale based on the Armoured cruiser size,Battlecruisers,Pre-Dreadnoughts& Dreadnoughts will be larger,while Protected cruisers,Light cruisers & Destroyers will be smaller,by approx 10 pixel per ship type + or -.[8D]

Hi hueglin another ship class added for you.[;)]

Austro / Hungarian Dreadnought Tegetthoff class.[;)]



Class overview
Builders: Three at Stabilimento Tecnico Triestino yard Trieste
Szent István in Danubius yard, at Fiume (Rijeka)
Operators: Austria–Hungary
Preceded by: Radetzky-class
Succeeded by: Ersatz Monarch-class
Completed: 4
Lost: 1
Retired: 3
Preserved: 0
General characteristics
Type: Dreadnought battleship
Displacement: 20,000 tons standard
21,600 tons max

Length: 152.2 m (499 ft 3 in)
Beam: 27.3 m (89 ft 8 in)
Draft: 8.9 m (29 ft)
Propulsion: Szent Istvan: Twelve Babcock & Wilcox boilers fitted with four AEG Curtis steam turbines totalling 26,400 shp (19,700 kW) on four shafts.
All other ships: Twelve Yarrow boilers fitted with four Parsons steam turbines totalling 27,000 shp (20,000 kW) on four shafts.

Speed: 20 knots
Range: 4,200 nmi (7,780 km) at 10 knots (19 km/h) with 2,000 tons of coal
Complement: 1,087
Armament: 12 × 12-inch (305 mm) guns in triple turrets
12 × 5.9-inch (150 mm) guns in single casemates
18 × 11 pdr guns in single mountings
4 × 21-inch (533 mm) torpedo tubes

Armor: Belt : 6 - 11 inches
Turrets : 2 - 11 inches
Deck : 1.2 - 2 inches
Casemates : 4.7 inches

Hi folks been quite some time since I done any art for the Italian navy,so here is the first off my Improved and updated art for the St.Bon class Pre-dreadnought.[8D]

Regina Margherita class Pre-Dreadnought.

Looking Good [8D]

Italian Regina Elena class Pre-Dreadnought[;)]

Italian Dante Alighieri class Dreadnought [:)]

Italian Giuseppe Garibaldi class Armoured cruiser[8D]

The correct name of the above italian cruiser is Giuseppe Garibaldi.
Regards
marioa

Yip marioa, I had noticed my spelling mistake earlier,must have edited it at the same time you noticed it,apart from that how do you like the ship art ?

Italian Seaplane carrier Giuseppe Miraglia[;)]

Italian Conte di Cavour class Dreadnought.[8D]

Italian Andrea Doria class Dreadnought.[8D]

New version Italian Pre-dreadnought St Bon class.