Page 17 of 27
RE: JTCS meets PG3D mod-upgrade
Posted: Sat Jun 21, 2008 7:46 pm
by Dumnorix
I would welcome it much, if you could produce a perfectly new map in correct north adjustment. In addition I need urgently more mapmaker for the Barbarossa project.
H.Balck
RE: JTCS meets PG3D mod-upgrade
Posted: Sun Jun 22, 2008 6:21 pm
by Bioman
Dumnorix:
I have downloaded your WW2 project and I have had 2 problems that make it unplayable. First in the 2D mode almost all of the non graphical unit icons are displayed as AT symbols. In the 3D mode there is a purple border to most of the terrain features like the roads and rivers which make the map impossible to use.
I will say that the work you have done on this project is awesome.
Nick
RE: JTCS meets PG3D mod-upgrade
Posted: Sun Jun 22, 2008 6:29 pm
by Dumnorix
Hallo Nick
First in the 2D mode almost all of the non graphical unit icons are displayed as AT symbols
Please use combatview
1 and overview
5, 2d
4 is not correct now - it comes later with my new setup JTCS meets PG3D WWII v.1.05.
In the 3D mode there is a purple border to most of the terrain features like the roads and rivers which make the map impossible to use.
Befor you start with my mod, please change your desktop to 800x600 and 16-bit. Than you have no graphical errors !
I will say that the work you have done on this project is awesome.
Thanks Nick - I work on this in the last 4 years and many new scenarios and campaigns comes to you in the future.
H.Balck
RE: JTCS meets PG3D mod-upgrade
Posted: Mon Jun 23, 2008 8:31 am
by Huib
ORIGINAL: Dumnorix
In the 3D mode there is a purple border to most of the terrain features like the roads and rivers which make the map impossible to use.
Befor you start with my mod, please change your desktop to 800x600 and 16-bit. Than you have no graphical errors !
Setting it to 16 bit colors was sufficient on my system. Didn't have to set it to 800x600.
Huib
RE: JTCS meets PG3D mod-upgrade
Posted: Mon Jun 23, 2008 2:23 pm
by Dumnorix
Hallo Huib
Ja das ist schon richtig, aber die Grafik leidet trotzdem, da die Details in höherer Auflösung verwischt werden. Außerdem hat man nicht mehr das originale PG3D-feeling !
Gruß H.Balck
RE: JTCS meets PG3D mod-upgrade
Posted: Mon Jun 23, 2008 8:48 pm
by Huib
Hmmm. I prefer the wider screen of 1680x1050
Perhaps a personal preference.... The 800x600 actually looks a lot worse than in this picture below and the 1680x1050 looks sharper than shown here...
http://i305.photobucket.com/albums/nn21 ... 00_600.jpg
http://i305.photobucket.com/albums/nn21 ... 0_1050.jpg
RE: JTCS meets PG3D mod-upgrade
Posted: Mon Jun 23, 2008 9:02 pm
by Dumnorix
Hallo Huib
I play with 800x600 - this is my favorit, otherwise you can go back to the original Matrix-graphic. The name is JTCS meets PG3D not JTCS meets something. In addition you did not install the correct winter diagrams !!! (Extra file)
Play the original game, this is better for you !
H.Balck
RE: JTCS meets PG3D mod-upgrade
Posted: Mon Jun 23, 2008 9:25 pm
by Huib
My laptop cannot handle 800 x 600. The screen is blurry when I do so. Many new flatscreens need a certain resolution. For example my Samsung flat screen is only sharp at 1280x1024.
RE: JTCS meets PG3D mod-upgrade
Posted: Tue Jun 24, 2008 8:44 am
by Dumnorix
News for the next setup JTCS meets PG3D version 1.05: (comes on 29th june 2008)
1. new supply system - all HQ range + 50% (Differences in the war years considers).
2. error with the armoured Resictance eliminated.
3. Hexfields fields with hedges/Bocages (original Dry rise paddys) block now the line of sight (high=5m) From a next hill you can look thus over it.
4. Hexfields high mountains (original flooded rise paddys) also. (high=50m) From a next hill you can not look thus over it.
5. ATG-feature included (Matrix patch 1.03)
6. completed Kanev-scenario.
7. LCG Fall Gelb patched to matrix version 1.03 and a new scenario ST.Quentin
8. new workingphase Barbarossa armygroup center
9. New Airrecons-feature for all nations included (Matrix patch 1.03)
H.Balck
RE: JTCS meets PG3D mod-upgrade
Posted: Sat Jun 28, 2008 5:08 pm
by Witti44
Hi Balck,
freue mich schon auf deine V.1.05! Wird erstmal die letzte Version sein die ich spielen werde. Hab nur noch eine Woche Urlaub und dann gehts schon in den nahen Osten.
Ich weiß es ist immer leicht Vorderungen zu stellen aber planst Du denn deine Grafiken an 32bit und höhere Auflösungen anzupassen?
Somit hätte man einen besseren Überblick über die Einheiten.
Planst Du eventuell bis Ende des Jahres noch einige MP Szenarien für JTCS umzuwandeln oder ist bei dir jetzt erstmal Fall Gelb und Barbarossa Schwerpunkt?
Hab gesehen das 1.03 draußen sein soll. Braucht man den denn für deine neue Version? Habe leider noch keinen Link dazu gefunden
RE: JTCS meets PG3D mod-upgrade
Posted: Sat Jun 28, 2008 6:05 pm
by Dumnorix
Hallo Wittmann
Ich weiß es ist immer leicht Vorderungen zu stellen aber planst Du denn deine Grafiken an 32bit und höhere Auflösungen anzupassen?
Somit hätte man einen besseren Überblick über die Einheiten.
Kommt mit 1.06.
Planst Du eventuell bis Ende des Jahres noch einige MP Szenarien für JTCS umzuwandeln oder ist bei dir jetzt erstmal Fall Gelb und Barbarossa Schwerpunkt?
Operation Husky (Invasion in Sizilien) kommt Ende Juli mit 1.06, ansonsten werde ich weiter an Barbarossa arbeiten. 1.05 kommt morgen mit dem fertigen Kanev-scn.
Hab gesehen das 1.03 draußen sein soll. Braucht man den denn für deine neue Version? Habe leider noch keinen Link dazu gefunden
"Bruchste neche - eenfach morjen 1.05 drübberbügeln un schone kannste Pio spiele. Un mien Dialekt hier is for die Amerikans, domit die dasse nich so schnelle schnaggeln - weest de !".
Glück auf !
H.Balck
PS: Übrigens Nordthüringisch !
RE: JTCS meets PG3D mod-upgrade
Posted: Sat Jun 28, 2008 8:47 pm
by Witti44
Na da freu ich mich schon drauf! Besonders auf die Pios
1.04? ich dachte deine nächste version soll 1.05 sein!? 1.04 ist doch schon draußen oder irre ich da?
Sag mal wäre es möglich irgendwie eine spielbare Version von deinem großartigen Stalingradszenario zu bekommen?
Ich weiß für JTCS ist es noch nicht fertig und so wie ich dich verstanden habe wird das auch dieses Jahr nicht mehr in Angriff genommen. Aber für WF oder DG war es ja fertig. Wäre es möglich mir da ein kleines Paket für WF / DG zu schnüren das ich dort zumindest schonmal nach Stalingrad reinschnuppern kann?

Bedenke ich bin in einer Woche für über vier monate von deinen updates abgeschnitten! Wird sicher eine harte Zeit ohne irgendein update oder neue features der neuen versionen
Wäre prima wenns klappen würde!
RE: JTCS meets PG3D mod-upgrade
Posted: Sat Jun 28, 2008 8:55 pm
by Dumnorix
Hallo Wittmann
Ja richtig morgen Abend kommt v.1.05. Ich werd mal schauen, ob ich das mit Stalingrad schaffe - DG oder WF ?
Gruß H.Balck
RE: JTCS meets PG3D mod-upgrade
Posted: Sat Jun 28, 2008 9:02 pm
by Witti44
WF oder DG ist mir eigentlich egal. Ich habe beides. WF habe ich allerdings die Goldversion 1.06 glaube ich. Müsstest mir nur eben durchgeben welchen Patch ich dafür noch brauche.
RE: JTCS meets PG3D mod-upgrade
Posted: Mon Jun 30, 2008 3:52 pm
by IronPig
Hallo, bin auch mal wieder da. Was habe ich da gelesen? 1.05 und 06 ist schon geplant?! Das ist ja klasse! Wann meinst du können wir uns daran ergötzen? [:D]
RE: JTCS meets PG3D mod-upgrade
Posted: Tue Jul 01, 2008 4:08 am
by Dali
Hi, send you new Icons 18.8.2008:
ZiS-5 25mm 72-K40 AA Gun (1xbarrels) + unitskard
YAG-10 76,2mm 3K AA guns + unitscard
7,5cm PaK 40 auf H-35(f) + unitscard
And 27.6.2008:
ZiS-42 halftrack auf 37mm AA Gun
ZiS-6 auf 2x25mm AA Gun (this variant existing late war 44-45)
SdKfz 6 5t prime movers
This icons represented BN L7, early variants, 1935-37 short track carriage
http://e-carzone.com/bussing-nag/bn_l_7 ... 37/1.shtml
Receive you ??
Dali
RE: JTCS meets PG3D mod-upgrade
Posted: Tue Jul 01, 2008 2:58 pm
by Dumnorix
Hallo Dali
Ich habe beide e-mail nicht erhalten ! Bitte sende sie mir doch noch einmal an
weinertweinertm@aol.com
Vielen Dank für diese tolle Arbeit - ich freue mich am meisten aud das sdkfz 6.
Gruß H.Balck
RE: JTCS meets PG3D mod-upgrade
Posted: Wed Jul 02, 2008 6:30 am
by Dali
Hi,your mail adress its problems. My mail returned, adress failed.
Send you yesterday new icons(8:21 AM), returned.
there:
The original message was received at Wed, 02 Jul 2008 08:21:12 +0200
----- The following addresses had permanent fatal errors ----- <
weinertweinertm@aol.com>
----- Transcript of session follows ----- .. while talking to mailin-01.mx.aol.com <<< 554- (RTR:CH)
http://postmaster.info.aol.com/errors/554rtrch.html
554 Connecting IP: 85.70.187.144
.. connection error: connection reset by peer/timeout
details:
Reporting-MTA: DNS; email.kunst.cz
Arrival-Date: Wed, 02 Jul 2008 08:21:12 +0200
Original-Recipient: RFC822; <weinertweinertm@aol.com>
Final-Recipient: RFC822; <weinertweinertm@aol.com>
Action: failed
Remote-MTA: DNS; mailin-01.mx.aol.com
Last-Attempt-Date: Wed, 02 Jul 2008 08:21:12 +0200
?????
Dali
RE: JTCS meets PG3D mod-upgrade
Posted: Thu Jul 03, 2008 7:54 am
by Dumnorix
Hallo Dali
Take this side to upload:
http://uploadhosted.filefront.com/
and send me the link here in my memberprofile.
H.Balck
RE: JTCS meets PG3D mod-upgrade
Posted: Sat Jul 05, 2008 5:57 pm
by Witti44
Hi Balck,
wie sieht es mit deiner neuen version aus?
Konntest Du bezüglich deiner alten Version vom Stalingradszenario für mich was regeln?
Frage nur weil ich nur noch sonntag und montag im Land bin und dann erst zum jahresende wiederkomme.
Wäre schön mit ner neuen version loszuziehen
