Matrix Games Forums

Just FYI, v1.01e will likely be out on Monday, trying to get one more code update in before the release and ran out of time today.

v1.01e Beta is now available in the Members Club. Please see the first post in this thread for details.

Please note that v1.01e replaces all previous version and can be installed on top of any previous version. If you are playing PBEM games, both players should update to v1.01e at the same time or for maximum safety stay on their previous version until the game is complete.

Any word on if/when the artillery call situation will be remedied?

Meaning showing the target area as you initially target the artillery? We're looking into that, no answer yet.

ORIGINAL: Erik Rutins

Meaning showing the target area as you initially target the artillery? We're looking into that, no answer yet.

Yessir!

dono if this was asked before, but will the patch allow me to continue with a started and well advanced campaign, or will i loose it and start over again?

thx,

himmel

No problem, should be just fine with single player campaigns.

sweet thx! [&o]

I patched last night part way through a saved boot camp scenario and everything went just fine.

yes all is fine and i can even load "older" saved games. gosch...did i mention how much i loooove this game?![:)]

Updated first post with v.1.01f change list.

v1.01f is now available in the Members Club. [8D]

I installed 1.01f and started replaying a saved game. I issued orders and all looked well. Didn't appear to have any sighting issues, as I had reported in support forum.

Before updating, I did unload all the mods - junk2drive's HUD, and Bil H's icons (using the JSCME tool). I thought I"d run 1.01f without mods for a while.

In any event, when the game started running after the orders phase, the eniter terrain when white. ie. I could still see trees as black wire frames, but grass, dirt, all the ground textures were snow white.

When play ended, I started looking at map, and when I rotated map, all textures came back. I think tried moving around and the terrain would pop in and out of being white, depending on level of zoom, or rotation, or tilt.

I decided to rebott my system and try again.

I was not able to duplicate this on the next turn, so it might have been a fluke.

I'll post with screen shots if it happens again. Just thought I'd give you a heads up.

Rick

I've seen that once in a blue moon - it's due to the driver going a bit wonky and is usually fixed by Alt-Tab out and Alt-Tab back in or game restart.

Ok, I exited game, rebooted my machine. then started up again and it hasn't happened. I"ll watch and unless it gets chronic I'll ignore it.

Thanks
Rick

Hi All,

I have had the problem as described above as well. But I have not seen it for a while now. I still do get an odd flash now and again but that is quite rare.

Regards John

v1.01g is now available, with further collision/pathfinding improvements. Please see the first post for details.

v1.01g Beta appears to have broken PBEM file generation. We hope to have a fixed version up tomorrow.

The issue that broke PBEM in v1.01g has been fixed. A new release will be up later today.

v1.01h is now available, please see the first post in this thread for details.