Page 1 of 1

No Control of Craft After Restart

Posted: Sat Jun 09, 2007 5:49 am
by cptsaxman
I just installed this game and the first go around went well... I shut the program down for supper and when I came back, I find that there is a big problem...

Whenever I lanuch a mission, the ship goes into an uncontrollable right corkscrew. I can not control the ship with my Saitek X52, the mouse or the keyboard. I can use non-directional/throttle commands on the keyboard only.

I have uninstalled the program once and re-installed it. I had the same thing happen. It worked fine until I shut it down. The next time I started the game I can not control the ship.

Any help would be greatly apprecaited.


RE: No Control of Craft After Restart

Posted: Sun Jun 10, 2007 7:39 pm
by wdboyd
Try clicking on NAV located on the HUD. Then click on it again to resume the nav route.

RE: No Control of Craft After Restart

Posted: Sun Jun 10, 2007 7:45 pm
by cptsaxman
Thank you for the suggestion... I have tried this... When you put the ship into autonav mode the craft operates normally, when you take it back out, it continues to corkscrew.


RE: No Control of Craft After Restart

Posted: Tue Jun 19, 2007 7:31 pm
by cptsaxman
After emailing with Milo, I was able to determine the issue.  The control configuration in the game had "both" joysticks selected even though my computer only has one joystick.  After changing the option to Joystick 1,  the issue was resolved.