Page 1 of 1
Results from...The Final Countdown
Posted: Mon Jun 11, 2007 2:36 pm
by Unhappy
Hopefully this works

RE: Results from...The Final Countdown
Posted: Mon Jun 11, 2007 3:01 pm
by Toby42
And just where did you get this Puppy at???
RE: Results from...The Final Countdown
Posted: Mon Jun 11, 2007 3:24 pm
by Unhappy
Ok...I have to admit that this game is growing on me a bit. Watching my A7's and A6's tear apart the Japanese navy was fun and made me giggle.
As others have mentioned all the basic parts for incorporating TG 68 (the Nimitz) are already built into the Pearl Harbor scenario.
All I did was the following:
1. Go into the editor
2. Load Pearl Harbor.CAW
3. VERY IMPORTANT!!!! Immediately Save As: Final Countdown.CAW so that you don't screw up your existing scenario.
4. Click on : Edit Warroom
5. Use left hand scroll box to find and select: Al SU - General
6. Use the lower right hand box select the second instance of: delete forces
7. In the lower center box select: TG 68
8. click: Remove (below the box)
9. click: Save Scenario (bottom left)
10. click: Back
11. click: Back
12. click Single Player and locate Final Countdown
This doesn't work perfectly - search isn't set up right for your E2 squadron - and I can't figure out how to get them to operate at night. There is NO AI configured for TG 68 so you can only play this scenario as the Americans. (or TG 68 wont do anything)
I'm still trying to figure it out.
If somebody has somewhere to post scenarios then I could email the .CAW file to them.
RE: Results from...The Final Countdown
Posted: Mon Jun 11, 2007 3:39 pm
by Toby42
Sounds like you're heading in the right direction...
RE: Results from...The Final Countdown
Posted: Mon Jun 11, 2007 4:51 pm
by Hertston
ORIGINAL: Unhappy
Ok...I have to admit that this game is growing on me a bit.
Perhaps you should change your handle to "Notquitesounhappy"? [:D]
The Final Countdown AI
Posted: Sun Aug 12, 2007 1:08 pm
by vinboni
To configure the AI for Nimitz you have to add it in the WarRoom... I made it and it works.
It's a work in progress but I can sand the file if someone wants it.
