Page 1 of 1
Ranges.
Posted: Mon Dec 10, 2007 9:27 pm
by andym
Is there any way of finding the distance to a certain point on the map.A sort of click on the group then click on the area needed?
RE: Ranges.
Posted: Mon Dec 10, 2007 9:44 pm
by roeddog
Hi Andy,
Ctl-f or Misc tab >> Calculate Rng & Brng. brings up a dialogue box to pick the target.
Regards,
Jeff
RE: Ranges.
Posted: Mon Dec 10, 2007 9:54 pm
by andym
I found that one ,i was just wondering if there was another less longwinded way?Maybe one for the wishlist?
RE: Ranges.
Posted: Mon Dec 10, 2007 10:29 pm
by FransKoenz
first click on a group [activate] then click [left] somewhere on the map
At the bottom you see the range in nm[;)]
RE: Ranges.
Posted: Mon Dec 10, 2007 10:30 pm
by andym
ORIGINAL: Taitennek
first click on a group [activate] then click [left] somewhere on the map
At the bottom you see the range in nm[;)]
Ooooooooo thanks very much Mister![&o]
RE: Ranges.
Posted: Mon Dec 10, 2007 10:51 pm
by FransKoenz
Your welcome![:D]
Don't forget to refuel in time[;)]
RE: Ranges.
Posted: Mon Dec 10, 2007 11:40 pm
by andym
Thar,sir,is VERY good advice LOL!