Page 1 of 1
Edit exclusion zone hexes?
Posted: Thu Jun 12, 2008 8:09 pm
by SweArmy
Hi !
I´m experimenting a little with a scenario. When I have added exclusion zone hexes can I then remove them in any simple way ?
So far I´ve only been able to change the terrain, the exclusion hex remains.
RE: Edit exclusion zone hexes?
Posted: Thu Jun 12, 2008 8:55 pm
by Veers
ORIGINAL: SweArmy
Hi !
I´m experimenting a little with a scenario. When I have added exclusion zone hexes can I then remove them in any simple way ?
So far I´ve only been able to change the terrain, the exclusion hex remains.
It's not simple, but if you do the same thing you did to put one on a hex to a hex that already has one, it will remove it. Right click->Exlution Zone 1/2.
RE: Edit exclusion zone hexes?
Posted: Fri Jun 13, 2008 4:41 am
by Boonierat
ORIGINAL: Veers
It's not simple, but if you do the same thing you did to put one on a hex to a hex that already has one, it will remove it. Right click->Exlution Zone 1/2.
Not simple?! Veers you're just too lazy man, it just requires a right click! [:D]
RE: Edit exclusion zone hexes?
Posted: Fri Jun 13, 2008 8:09 am
by Veers
ORIGINAL: Boonierat
ORIGINAL: Veers
It's not simple, but if you do the same thing you did to put one on a hex to a hex that already has one, it will remove it. Right click->Exlution Zone 1/2.
Not simple?!
Veers you're just too lazy man, it just requires a right click! [:D]
This I cannot deny! [:D]