Page 1 of 1
WiTP Tracker
Posted: Mon Feb 09, 2009 2:47 pm
by Hanzberger
Does this work for RHS?
RE: WiTP Tracker
Posted: Mon Feb 09, 2009 4:01 pm
by herwin
ORIGINAL: Hanzberger
Does this work for RHS?
It works fine for me.
RE: WiTP Tracker
Posted: Mon Feb 09, 2009 6:09 pm
by el cid again
The word is that it works - but only in the sense it works for all forms of WITP: it only works for one side or the other of a given game - you cannot create a sheet comparing economics for both sides using it. I suppose you could set it up on each side - and generate a tracker report at the end of each turn for each side - to get a total picture. WITP reports do give you other side economic totals - but not details place by place.
RE: WiTP Tracker
Posted: Mon Feb 09, 2009 7:46 pm
by Nemo121
Or, in english.... Yes it works although you'll have to download and RHS-specific file of base clusters if you want it to work properly. That's a pretty easy task though and if you want to avoid even that then you are free to simply and easily designate bases to belong to specific regions yourself.
E.g. I have my own customised region listings for my current game vs ACR and whenever a significant new base is captured it is just a minute's work to incorporate it into the base list.
RE: WiTP Tracker
Posted: Tue Feb 10, 2009 10:50 am
by Hanzberger
Ok Nemo, I have used it before for stock game. Where do I get this special file for RHS? Also I think I did something wrong on my install. Do you have to run the mod select utility? If so when exactly. The problem I had was (rhsaio) the computer took its turn, then on my first turn, I tried to send that Carrier from New Orleans out to the Pacific. Well the track it came up with was not thru the 'off map' slots, rather it just made a 'Crows fly' to the hex I designated. I'm guessing it's not recognizing the off map stuff, although the bases were there. [&:]
RE: WiTP Tracker
Posted: Tue Feb 10, 2009 11:29 am
by n01487477
Not sure about your RHS install problems, but the witptracker base cluster for RHS comes with the install in the "region-mappings" folder....
Just go file-import base region definitions and then traverse to the said folder and find the RHS file ... this will give you a good start point... change the bases at your pleasure from here.
RE: WiTP Tracker
Posted: Wed Feb 11, 2009 7:27 pm
by Mifune
Thank you n01487477 for that bit of information for using the WitP Tracker with RHS.
RE: WiTP Tracker
Posted: Thu Feb 12, 2009 12:35 pm
by herwin
ORIGINAL: herwin
ORIGINAL: Hanzberger
Does this work for RHS?
It works fine for me.
Except this morning for a new game!!!!