Problem with formation copying.........
Posted: Sun Mar 15, 2009 6:51 pm
Among the options in the scenario editor, in the "edit forces" settings, is one for copying a formation.
When I do this, however, it seems to "invalidate" the scenario. I've an earlier version confirmed as valid through the "view properties" check, but in copying and including the new formation in an OOB, then I get the "critical" warning in the view-properties check.
The added message is that I haven't "set objectives for all formations". Remove the copied formation, however, and the scenario becomes valid again.
But..... after modifying the copied formation to give it and its sub-units new names, deploy its units on map, and set an objective track for the formation, I still get the same error warning. [&:][&:]
Suggestions? I'm prepared to e-mail both scenario versions if that would help.
When I do this, however, it seems to "invalidate" the scenario. I've an earlier version confirmed as valid through the "view properties" check, but in copying and including the new formation in an OOB, then I get the "critical" warning in the view-properties check.
The added message is that I haven't "set objectives for all formations". Remove the copied formation, however, and the scenario becomes valid again.
But..... after modifying the copied formation to give it and its sub-units new names, deploy its units on map, and set an objective track for the formation, I still get the same error warning. [&:][&:]
Suggestions? I'm prepared to e-mail both scenario versions if that would help.