Adjust units loading display fault
Posted: Mon Aug 03, 2009 5:59 pm
Hi,
I noticed a display fault when I clicked on Adjust Load Troops. The screen will show the unit I'm loading but also an air unit that's not located in this base (San Diego). The air unit, No 273 Sqdn, is located in Trincomalee.
It's repeatable and I have one save from where I can recreate it and one where it exist.
Scenario is 1, The Full Campaign. I have executed the first historical turn with the computer as Japanese and me handling the Allies. The fault appears like this:
1. Load a Save made after executing Historical first turn.
2. Select Operations Mode Strategic Move for 2nd Marine Defense Battalion (5577) in San Diego.
3. Form new Transport TF with APD Waters, AP Harris and xAP Santa Maria.
4. Load Troops and Select 2nd Marine Defense (only unit listed).
5. Click Verify Load.
6. Click Accept Load.
7. Click Adjust Load Troops.
Display show both 2nd Marine Defense Battalion and No 273 Sqdn.
Regards
BPRE
I noticed a display fault when I clicked on Adjust Load Troops. The screen will show the unit I'm loading but also an air unit that's not located in this base (San Diego). The air unit, No 273 Sqdn, is located in Trincomalee.
It's repeatable and I have one save from where I can recreate it and one where it exist.
Scenario is 1, The Full Campaign. I have executed the first historical turn with the computer as Japanese and me handling the Allies. The fault appears like this:
1. Load a Save made after executing Historical first turn.
2. Select Operations Mode Strategic Move for 2nd Marine Defense Battalion (5577) in San Diego.
3. Form new Transport TF with APD Waters, AP Harris and xAP Santa Maria.
4. Load Troops and Select 2nd Marine Defense (only unit listed).
5. Click Verify Load.
6. Click Accept Load.
7. Click Adjust Load Troops.
Display show both 2nd Marine Defense Battalion and No 273 Sqdn.
Regards
BPRE