Page 1 of 1
loading with Transport tF only of AKL
Posted: Fri Aug 14, 2009 11:52 pm
by loricas
when try to load LCU with a TF only of AKL all work fine apart for support squad: there is space for it but are not loaded: in the save the TF in DEI base north of Darwin (Lauten?) are same days that loading a small AA unit: the only mode i find to procede is stop load..uload in another base--than made another trip to load the fragment..composed only of support squad: but again load only 1 squad per ship and stop. the same in the same save in the small OZ island near adelaide. Again a TF only with AKL and again trouble in loading support
RE: loading with Transport tF only of AKL
Posted: Sat Aug 15, 2009 9:03 am
by Iron Duke
AK,xAK and xAKL 's only carry cargo/equipment not troops
On the LCU screen look in the bottom left it tells you troop load requirement and cargo/equipment load requirement.
troops use AP, xAP, APA ship types
Cargo use AK,xAK,AKA ship types
Also use the Varify button when loading TF's
hope this helps
RE: loading with Transport tF only of AKL
Posted: Sat Aug 15, 2009 9:17 am
by Kumppi
AK, xAK and xAKL type ships can carry troops in their cargo space, but at a penalty. For example to load troops in an AK type ship you need 6 cargo capacity points for every troop load point loaded.
RE: loading with Transport tF only of AKL
Posted: Sat Aug 15, 2009 9:29 am
by Iron Duke
Kumppi,
thanks for the correction , missed that in the manual[&:]
RE: loading with Transport tF only of AKL
Posted: Fri Aug 21, 2009 10:00 am
by loricas
if the TF is composed of both AK and AKL (indifferent presence of non cargo ship) all work fine. the trouble is when the loading TF is only composed of AKL: for exemple a TF composed of AK and AKL of total of 10000 capacity load for 10000. a TF composed only of AKL loading unit load all but the support squads. and in a second time load only one squad for AKL: there is teorically remainig space aboard but it remain unused.
RE: loading with Transport tF only of AKL
Posted: Fri Aug 21, 2009 11:15 am
by Don Bowen
Sorry, seem to have missed this thread when it was created. I'll check out the save.
RE: loading with Transport tF only of AKL
Posted: Fri Aug 21, 2009 2:17 pm
by Don Bowen
Yes, there is a boundary load issue with loading troops into xAKL with only cargo capacity remaining at level 0 ports. Will adjust.
RE: loading with Transport tF only of AKL
Posted: Mon Aug 24, 2009 5:39 am
by Flying Tiger
just to confirm.... are you saying that after the patch we WILL be able to load support/troop loads onto AK only TFs? Albeit with load penalty?
RE: loading with Transport tF only of AKL
Posted: Mon Aug 24, 2009 9:46 am
by loricas
ORIGINAL: Flying Tiger
just to confirm.... are you saying that after the patch we WILL be able to load support/troop loads onto AK only TFs? Albeit with load penalty?
we can load support/troop onto AK only TF even now. the bug is only with AKL only TF
RE: loading with Transport tF only of AKL
Posted: Mon Aug 24, 2009 11:12 am
by Don Bowen
ORIGINAL: Flying Tiger
just to confirm.... are you saying that after the patch we WILL be able to load support/troop loads onto AK only TFs? Albeit with load penalty?
The issue hads nothing specifically to do with type of ship. It had to do with the method of calculating load cost offsets for loading troops into cargo space. For some ships that are very poor troop carriers (i.e. small ships with no troop capacity) the load cost offset for carrying troops is very high. For level zero ports the daily capacity is very low. The calculations for how-many-troops-can-I-load-on-this-ship-at-this-location returned a number less than the size of one squad. A minor tweak to this calculation will allow slow (painfully slow) loading.
Three good ideas:
1. Don't piss into the wind.
2. Never irritate Superman.
3. Use amphib ships and naval support to load/unload at tiny ports.