Page 1 of 1
DEFAULT SETUP
Posted: Fri Apr 09, 2010 5:50 pm
by commander tom
how do i get the default set up to work properly?????
as france i finished setting up and i get a message telling me to finish setting up or remove unit
[&:][&:]
RE: DEFAULT SETUP
Posted: Fri Apr 09, 2010 10:19 pm
by Dancing Bear
Tom, it might be because you have placed a leader, but not assigned him to a unit, but I am not entirely sure.
RE: DEFAULT SETUP
Posted: Sat Apr 10, 2010 12:54 am
by Grognot
"Unattached leader" and "placed empty corps" are two reachable ways to have a bad setup. It shouldn't be the case with a default setup unless you've overwritten it (which was possible to do once upon a time; haven't checked lately).
RE: DEFAULT SETUP
Posted: Mon Apr 12, 2010 11:00 am
by Marshall Ellis
ORIGINAL: commander tom
how do i get the default set up to work properly?????
as france i finished setting up and i get a message telling me to finish setting up or remove unit
[&:][&:]
You may have a unit that has no troops OR factors left to place.
It should zoom to and highlight the unit in question.