Matrix Games Forums

Hi all,

after installing CHS i have the following problem:

the offmap-bases shipping paths (panama and aden) are not existent on the extended map. everything else is fine.

any solutions here?

thanks.

ORIGINAL: bigbaba

Hi all,

after installing CHS i have the following problem:

the offmap-bases shipping paths (panama and aden) are not existent on the extended map. everything else is fine.

any solutions here?

thanks.

It sounds like you need to run MODSELECT.BAT...

For some reason, i have to run it twice when i do an install... so try it again if you have already done it.

thanks but modselect wont work on vista64....

ORIGINAL: bigbaba

thanks but modselect wont work on vista64....

ooops... not sure what to do then.

The only thing i can think of off hand is to manually replace the map file.

EDIT: To get the file names, you can look at the modselect.bat file.

You might try this file:

ART\Maps_Modified_v6\PWhex.dat

this should be the CHS mapfile, i think.

PM sent... let me know what happens! [:)]

Do a complete reinstall from scratch and very carefully follow the instructions because it's different for Windows XP and Vista.  That solved my problems with CHS.

ORIGINAL: tocaff

Do a complete reinstall from scratch and very carefully follow the instructions because it's different for Windows XP and Vista.  That solved my problems with CHS.

It's been so long since i had installed my CHS that i didn't even know there were separate directions for VISTA! [X(]

Good to know!! [&o]

strike! it works finaly. i realy dont know what i did rigth this time[;)] but i didnt use modselect.bat. i just replaced all witp data through the CHS mod data.

thanks rtrapasso and tocaff.

ORIGINAL: bigbaba

strike! it works finaly. i realy dont know what i did rigth this time[;)] but i didnt use modselect.bat. i just replaced all witp data through the CHS mod data.

thanks rtrapasso and tocaff.

Whew! Good job!!!

the trick is to copy the pwhex file from the andrews witp map AND extended map directly into the game folder.

beside that, just make a copy of witp and then you dont need modselect.bat. you can directly replace all the files in the art folder with the chs files.

that for the folks with similar problem.

A word of advice: copy over the CHS folder onto a CD... if something goes wrong later, you can just recopy the file over onto an installation of WITP.

This is important if you are playing PBEM... the files for download have been known to change (with upgrades, etc., although this is less likely these days)... if the files change, you can no longer download the old files, and there will be sync problems.

So best to copy them before problems arise.