Page 1 of 1
I don't remember it doing this before
Posted: Fri Oct 28, 2011 9:28 pm
by Commanderski
When I click on a unit the way points for all the units show up, not just for the individual or even just the regiment but all of them. Did it do that before or is there a problem or did I forget to do something?
RE: I don't remember it doing this before
Posted: Fri Oct 28, 2011 9:33 pm
by Mobius
ORIGINAL: Commanderski
When I click on a unit the way points for all the units show up, not just for the individual or even just the regiment but all of them. Did it do that before or is there a problem or did I forget to do something?
This gets cycled through different levels by using the 'U' key.
RE: I don't remember it doing this before
Posted: Fri Oct 28, 2011 9:44 pm
by Commanderski
Thank you! It's been a while. That's much better.
RE: I don't remember it doing this before
Posted: Fri Oct 28, 2011 10:45 pm
by oldspec4
I'm kinda in the same situation after downloading the new beta...took me some time to re-familiarize myself w/ commands, etc.
RE: I don't remember it doing this before
Posted: Sat Oct 29, 2011 12:01 am
by rickier65
You might want to recheck both your configuration and your option settings. It's possible these were reset to default values in the patch.
Thanks
rick
RE: I don't remember it doing this before
Posted: Sat Oct 29, 2011 8:19 am
by oldspec4
I checked both configuration and option settings prior to starting under the new beta. No settings had changed.
RE: I don't remember it doing this before
Posted: Sat Oct 29, 2011 2:27 pm
by rickier65
ORIGINAL: oldspec4
I checked both configuration and option settings prior to starting under the new beta. No settings had changed.
Oldspec,
Thanks for checking that. I'm glad that's the case. When I was testing I did clean installs between builds so naturally my setting reverted back and I never did check.
Thanks
rick