Page 1 of 1
Refit Cavalry Corps
Posted: Fri May 11, 2012 9:50 pm
by glvaca
I seem to notice a very slow replacement rate for Cavalry Corps during the first winter. Just going into May and it seems to have picked up.
I have plenty of ARM's and 400+ calvalry squads in the pool, but they are just not getting to the Corps.
The Corps are located on a functioning RR hex far to the rear, no movement before. This behavior persists for several weeks during first winter.
Could this be hardcoded to balance things out?
RE: Refit Cavalry Corps
Posted: Fri May 18, 2012 10:22 am
by glvaca
bump, anyone?
RE: Refit Cavalry Corps
Posted: Fri May 18, 2012 12:26 pm
by Denniss
I remember to have seen it in an earlier test but can't remember the exact cause. What's the component not getting enough replacements?
Could you upload a savegame?
What's the WitE .exe version used and under which version was the game started?
RE: Refit Cavalry Corps
Posted: Fri May 18, 2012 6:01 pm
by glvaca
The game started at one of the later 1.05 patches and is now at 1.06.08.
Can get you a safe if you like.
Mostly Cav squads with plenty in the pool sitting idle. Had my cav corps on refit most of february and March but they received very few replacements during that time. It seems that from April/May things started to get going again.
RE: Refit Cavalry Corps
Posted: Fri May 18, 2012 8:10 pm
by Denniss
Remember, squads in pool is just the equipment, you also need sufficient free active manpower to send equipment to units.
RE: Refit Cavalry Corps
Posted: Fri May 18, 2012 9:53 pm
by glvaca
I was receiving around 120k per turn at that time. Armaments were plenty. A lot of rifle units were being brought back up to strength at the same time.
But there's not really anything different later.
If I'm the only one who've seen this then it's probably just a coincidance.
RE: Refit Cavalry Corps
Posted: Sat May 19, 2012 5:36 pm
by Denniss
Rifle/tank units may have a higher priotity for reinforcments although this may also be affected by leader rolls.
RE: Refit Cavalry Corps
Posted: Mon May 21, 2012 9:00 pm
by glvaca
Thanks for the answers.
Could you elaborate a bit on the leader rolls?
In fact, could you outline a bit of how replacements are affected or distributed?
I'd really like to know a little more about this works. Thanks!