Page 1 of 1
Japanese Production - Failed to Produce
Posted: Sat Jun 22, 2013 5:16 pm
by Capt Cliff
It sometime gets frustrating when I get a factory that fails to produce, and it is not intuitively obvious why it didn't. Perhaps if we had a mouse over message or a right click on the red X which tells the player why the production failed?
RE: Japanese Production - Failed to Produce
Posted: Sat Jun 22, 2013 10:24 pm
by el cid again
Generally production will fail because what is needed for it is not present:
LI will fail if there are not enough resources
HI will fail if there are not enough resources AND/OR if there is not enough fuel
Aircraft engines, aircraft, ships, armaments, etc will fail if there are not enough HI
points (or, for aircraft, not enough engines of the right sort).
RE: Japanese Production - Failed to Produce
Posted: Sat Jun 22, 2013 11:53 pm
by michaelm75au
I thought with the Industry Management screen the lack of resources is shown in RED when a factory fails to produce.
RE: Japanese Production - Failed to Produce
Posted: Sun Jun 23, 2013 1:34 pm
by Lokasenna
ORIGINAL: michaelm
I thought with the Industry Management screen the lack of resources is shown in RED when a factory fails to produce.
I thought so too.
If it was an aircraft factory that failed to produce, check the engines. This is actually not all that uncommon, especially when you're just getting your industry into some sort of order at the start of the game or after a major change in production (new engine coming online or something).
RE: Japanese Production - Failed to Produce
Posted: Mon Jun 24, 2013 1:32 pm
by Capt Cliff
ORIGINAL: michaelm
I thought with the Industry Management screen the lack of resources is shown in RED when a factory fails to produce.
I am not seeing that.
RE: Japanese Production - Failed to Produce
Posted: Tue Jun 25, 2013 8:24 am
by Uncivil Engineer
ORIGINAL: Capt Cliff
ORIGINAL: michaelm
I thought with the Industry Management screen the lack of resources is shown in RED when a factory fails to produce.
I am not seeing that.
I have seen this, too - a failure with no red X. I think it may be due to the sequence of events. HI fails due to lack of fuel, but thne a refinery makes fuel at the same base, so the industry management screen shows enough fuel, but there wasn't enough when the HI check was made. I'm not absolutely sure of this because I don't know the sequence that the program checks these things, but it's my "guess".
RE: Japanese Production - Failed to Produce
Posted: Tue Jun 25, 2013 9:04 am
by Sardaukar
I bet it's lack of fuel. I think base indurstry needs excess of "needed" to produce. Not sure, though.
RE: Japanese Production - Failed to Produce
Posted: Tue Jun 25, 2013 12:15 pm
by Shellshock
You can also get the red X if the hex the particular industry or resource center is located at, is being shared with an unwelcome guest, like an enemy unit.