Page 1 of 1
Groups in editor
Posted: Sat Sep 28, 2013 9:04 pm
by Alejo1968
I added units but cannot find a way to conform with them a group: 3 ships, they move in the area I created with the RPs, but they do it independently between each other. Same happens with a/c. Tried to put them in the AB as ready units (found how to make available the proper weapons), but as soon as they t/o (with the order "launch as a group", they land immediately.
Any help would be welcome.
RE: Groups in editor
Posted: Sat Sep 28, 2013 9:20 pm
by mikmykWS
To group units select all of them and press the g key which groups them. Then assign to the mission so they travel together in formation. If you drop aircraft please remember to set their home base (right click, select new home base, click on homebase).
If you have air units based at an airbase create the mission in the mission editor and let them take off when the mission triggers. The mission logic groups and launches them for you.
RE: Groups in editor
Posted: Sat Sep 28, 2013 9:30 pm
by Alejo1968
ORIGINAL: mikmyk
To group units select all of them and press the g key which groups them. Then assign to the mission so they travel together in formation. If you drop aircraft please remember to set their home base (right click, select new home base, click on homebase).
If you have air units based at an airbase create the mission in the mission editor and let them take off when the mission triggers. The mission logic groups and launches them for you.
Thanks a lot