EMCON radar settings chance to passive.
Posted: Wed Oct 09, 2013 7:34 am
Hi,
Don't know if this has been reported already (probably has but I'm in a bit of a hurry):
1. Start tutorial 'Basic training air operations 1983'.
2. When second message occurs: Define a patrol area as suggested in the tutorial message.
3. Add new mission, add tomcats to mission, Click 'Mission Doctrine / ROE / EMCON.
4. On 'EMCON Settings' tab uncheck 'Inherit from parent'.
5. Notice that 'Radar' is set to 'Active'. (Don't touch it).
6. Close 'Doctrine & ROE for mission' window.
7. Close mission editor.
8. Open mission editor again for mission created above.
9. Click 'MIssion Doctrine / ROE / EMCON' again and go to 'EMCON Settings' tab again.
10. 'Radar' is now set to 'Passive'?!
Marvin
Don't know if this has been reported already (probably has but I'm in a bit of a hurry):
1. Start tutorial 'Basic training air operations 1983'.
2. When second message occurs: Define a patrol area as suggested in the tutorial message.
3. Add new mission, add tomcats to mission, Click 'Mission Doctrine / ROE / EMCON.
4. On 'EMCON Settings' tab uncheck 'Inherit from parent'.
5. Notice that 'Radar' is set to 'Active'. (Don't touch it).
6. Close 'Doctrine & ROE for mission' window.
7. Close mission editor.
8. Open mission editor again for mission created above.
9. Click 'MIssion Doctrine / ROE / EMCON' again and go to 'EMCON Settings' tab again.
10. 'Radar' is now set to 'Passive'?!
Marvin