Page 1 of 1

Mining your own ports

Posted: Wed Oct 09, 2013 10:14 pm
by wga8888
If a ML in pearl be put in a minelaying mission and ordered to Pearl, will it lay mines in the port?

Java starts with some ML, they start with mines on board. However they have no port to reload and some have very short range to actually travel very far.

RE: Mining your own ports

Posted: Wed Oct 09, 2013 11:31 pm
by dr.hal
Yes it will be termed a "defensive minefield". You can always augment your own minefields.

RE: Mining your own ports

Posted: Thu Oct 10, 2013 3:18 pm
by tocaff
Do forget that you must set the TF to Lay Mines or they won't do it.

RE: Mining your own ports

Posted: Sat Oct 12, 2013 2:17 am
by wga8888
I never thought to look under the mission to 'lay mines'; five months of pointless activity. Thanks

RE: Mining your own ports

Posted: Sat Oct 12, 2013 2:28 am
by wga8888
I looked and did not find a setting for Lay mines other than Set Mission to Mine Warfare. I am using WITP not AE, should there be a difference.

RE: Mining your own ports

Posted: Sun Oct 13, 2013 5:58 am
by turkey
You'll find the option to lay mine / not to lay mines on the TF screen in the centre (below the picture). its same place as the unload / do not unload option on a transport TF. Happy mining.

RE: Mining your own ports

Posted: Sun Oct 13, 2013 11:21 am
by tocaff
All you need to do is form the TF undock it, set the base as the destination and hit the button to lay mines and they'll do it.

RE: Mining your own ports

Posted: Wed Oct 16, 2013 9:51 pm
by wga8888
thanks,. I found the:
laymine/not lay mine
speed control [cruise/mission/full]
auto disband/ do not autodisband
refuel ok/do not refuel
Patrol do not retire/retirement allowed.

never notices this before after many turns of play; was ussing the mission settings on teh far right column.