Page 1 of 1
Possible bug--A 130 Ranger class (CWDB)
Posted: Wed Oct 09, 2013 10:35 pm
by Mgellis
I'm working on a scenario with the A 130 Ranger class tanker. When I start it up, once it starts moving, it BLEEDS fuel, running low and ending up dead in the water after only an hour or so. Not sure what causes this...maybe the fuel consumption rate is set too high?
RE: Possible bug--A 130 Ranger class (CWDB)
Posted: Wed Oct 09, 2013 10:49 pm
by Mgellis
Hmmm...it happened with the A 207 Wave Class, too...but not the Triumph (R 16 carrier), or the V-class destroyers. Weird.
RE: Possible bug--A 130 Ranger class (CWDB)
Posted: Wed Oct 09, 2013 11:00 pm
by mikmykWS
Hi Mark
Can you post the scenario. We'll take a look.
Mike
RE: Possible bug--A 130 Ranger class (CWDB)
Posted: Thu Oct 10, 2013 10:49 am
by Mgellis
I actually took the tankers out of the scenario--I figured if the ships are off the coast of Venezuela they can just refuel at Jamaica after the scenario is over--but I can put them back in for a test version of the scenario and post it here this evening.
RE: Possible bug--A 130 Ranger class (CWDB)
Posted: Thu Oct 10, 2013 8:55 pm
by Mgellis
Okay, I apologize in advance for another newbie question...where is the "attach file" command so I can post the scenario? Or am I supposed to post it somewhere else? Thanks.
RE: Possible bug--A 130 Ranger class (CWDB)
Posted: Thu Oct 10, 2013 9:17 pm
by mikmykWS
Hi Mark
Reproduced and issue logged for Paul to look at. Looks like something to do with the db entries themselves.
Mike