Page 1 of 1
Placing Start Units Out of Deployment?
Posted: Sat Nov 02, 2013 2:43 pm
by deadsunwheel
I was just wondering how to place units out of their forces regular deployment area. This type of deployment shows up in several scenarios but there seems to be no obvious way to do this in the editor.
RE: Placing Start Units Out of Deployment?
Posted: Sat Nov 02, 2013 2:47 pm
by Mad Russian
What do you mean?
Do you have a screen shot of an example?
Good Hunting.
MR
RE: Placing Start Units Out of Deployment?
Posted: Sat Nov 02, 2013 2:53 pm
by MikeAP
ORIGINAL: deadsunwheel
I was just wondering how to place units out of their forces regular deployment area. This type of deployment shows up in several scenarios but there seems to be no obvious way to do this in the editor.
I think this can be done by first clicking on a hex, then appending a unit to the map. I could be wrong.