B469 - Jump to location
Posted: Fri Nov 29, 2013 2:47 pm
New features look great! Thanks for your great work.
I have a small issue with the jump to location feature. When I create two jump points on the same map view the jump between locations is not instant or sometimes only happens after I touch the zoom level.
Reproduce:
1) Create three facilities (Jump1-3)
2) Zoom to 120nm on Jump1 and assign the 1 key.
3) Navigate to Jump3 using the right mouse button (no zoom change!) and assign the 3 key.
4) Zoom out and assign the 2 key to Jump2.
5) I can jump 1->2->3 instantly, but 1->3 does not work (or at least not until I touch the zoom or after a few secs)
6) Same behaviour if I jump to 1, move the map around with the right mouse button and jump back to 1.
The attached scenario is setup as above and displays this behaviour always (at least for me).
I have a small issue with the jump to location feature. When I create two jump points on the same map view the jump between locations is not instant or sometimes only happens after I touch the zoom level.
Reproduce:
1) Create three facilities (Jump1-3)
2) Zoom to 120nm on Jump1 and assign the 1 key.
3) Navigate to Jump3 using the right mouse button (no zoom change!) and assign the 3 key.
4) Zoom out and assign the 2 key to Jump2.
5) I can jump 1->2->3 instantly, but 1->3 does not work (or at least not until I touch the zoom or after a few secs)
6) Same behaviour if I jump to 1, move the map around with the right mouse button and jump back to 1.
The attached scenario is setup as above and displays this behaviour always (at least for me).