Page 1 of 1

Supply Percentage

Posted: Tue Dec 24, 2013 5:09 pm
by Vease101
If I set a unit at 50% supply what exactly does it mean? In certain situations where units are a long way from the front or Engineer units that won't be used for some time I set them at 50% thinking that this frees up supplies to be sent to other units that need them more urgently. Is this how it actually works or does it just mean that the HQ for those units hoards the difference and doesn't actually pass it on?

RE: Supply Percentage

Posted: Thu Dec 26, 2013 7:21 am
by Vic
See chapter 16 in the manual but in short what it does is limit supplies sent. It will have little consequence for 100% readiness units, but will affect low readiness units that will now consume less but at the cost of not recovering readiness (or only partially). It should be used if you are running low on supplies in general or in a pocket to prioritize which units will receive the majority of the supplies that are available.

Best,
Vic

RE: Supply Percentage

Posted: Thu Dec 26, 2013 10:50 am
by Vease101
Thanks for the reply Vic, it works kind of how I thought. Why would limiting supplies not seriously affect a unit at 100% readiness? I understand the point about units at less than 100% not recovering readiness but surely a lack of supplies must have some consequence for movement and/or combat?

RE: Supply Percentage

Posted: Thu Dec 26, 2013 11:17 am
by Vic
Only if basic supply need is not met (which you cannot simulate since minimum supply rate you can set is 50%) will readiness start to decrease.

Furthermore units will lose readiness when moving or doing combat. Not very advisable to do this for multiple turns with '50% supply' units.

Best,
Vic