Page 1 of 1
problem with the editor
Posted: Mon Jun 02, 2014 7:12 am
by fran52
The problem is that, after placement of some polygons, there is the message :there are already six polygons in the ex.There is no possibility to add others polygons also if in the ex there are none.
So is not possible to edit new scenarios.
I use the patch 1.10.
RE: problem with the editor
Posted: Tue Jun 03, 2014 7:07 am
by fran52
Sorry for the previous post,but i think to have done a banal error.Probably there is any problem in the editor instead i have done a big mistake.
Problem closed.
RE: problem with the editor
Posted: Thu Jun 05, 2014 12:43 pm
by jonj01
After you place a polygon in a hex, you have to choose the next hex to place a new polygon.
What I do is.
Choose hex
hit f4(brings up polygon menu)
add polygon
hit f2 (brings up unit menu)
choose next hex
hit f4
Repeat.
RE: problem with the editor
Posted: Fri Jun 06, 2014 7:39 am
by fran52
Thank you Jonj ,i have already understood the mistake.Anyway ,sometime,the polygon don'exist.This mean that sometime,not always,i put a polygon but the los remain clear.