Page 1 of 1
Access Violation Error Message
Posted: Mon Apr 06, 2015 8:55 am
by kool_kat
Gents: [8D]
I'm developing a scenario, but receiving an access violation error message after I selected my initial forces.
Can you take a look at the scenario file? Let me know how to correct the error message? [&:]
File attached.
RE: Access Violation Error Message
Posted: Mon Apr 06, 2015 9:25 am
by kool_kat
Gents: [8D]
NVM. File is working correctly now. I "believe" some of the units were not in valid setup hexes when
I first selected the forces? [&:]
RE: Access Violation Error Message
Posted: Mon Apr 06, 2015 10:03 am
by CapnDarwin
We will check it out this evening and let you know what we see.
RE: Access Violation Error Message
Posted: Mon Apr 06, 2015 10:56 am
by cbelva
Mike, which force were you selecting? Did it give the access violation as you "selected the force" or when you tried to save it? Thanks
RE: Access Violation Error Message
Posted: Mon Apr 06, 2015 11:19 am
by kool_kat
ORIGINAL: cbelva
Mike, which force were you selecting? Did it give the access violation as you "selected the force" or when you tried to save it? Thanks
I was receiving the error message when I selected either Force 1 or Force 2. I would click on a unit and immediately
the error message would display. However, all error messages were prior to the scenario being saved for
the first time.
Note - I am able to load the saved scenario, click on units, move them etc. with no error message displaying.
Maybe the error message is associated only when all the initial scenario perimeters not being met? (e.g. Must have a
player briefing for each side. Must have at least one victory hex, etc.)