Page 1 of 1
Minor UI issue
Posted: Thu Sep 24, 2015 10:57 am
by TheWombat_matrixforum
One small bug I noticed (I think it's a bug): the C command to show contours actually shows hex outlines, and the Ctrl-X command to show hex outlines...does nothing.
RE: Minor UI issue
Posted: Thu Sep 24, 2015 12:45 pm
by Crossroads
I am not at my PC but I recall they are both ON by default, but when Contours are ON the hex grid does not show. Hence, when you toggle Contours OFF the hex grid shows.
Which is sort of the intention, by toggling contours you either see them or the hex grid. Otherwise toggling Contours OFF would show just a map with no hex outlines either.
Make any sense?
RE: Minor UI issue
Posted: Thu Sep 24, 2015 1:45 pm
by TheWombat_matrixforum
ORIGINAL: Crossroads
I am not at my PC but I recall they are both ON by default, but when Contours are ON the hex grid does not show. Hence, when you toggle Contours OFF the hex grid shows.
Which is sort of the intention, by toggling contours you either see them or the hex grid. Otherwise toggling Contours OFF would show just a map with no hex outlines either.
Make any sense?
Hmm, I'll check that. I didn't see any contours either but I probably just missed them. Thank you!
EDIT: Yeah, my bad. Once you explained it, it makes sense. Everything is working there. Thanks again!
RE: Minor UI issue
Posted: Thu Sep 24, 2015 3:13 pm
by Crossroads
It was a legitimate question mate, the two options do overlap a tad [:)]