Cycle Terrain issue?
Posted: Sat Dec 12, 2015 12:07 pm
Hello,
I notice an issue with "Terrain cycle" function on MAP Editor.
During Map Editing I use Terrain cycle to add variation on the map (eg to have different special building on adjascent hexes),Everything looks fine on display so far.
But after I saved the map and re open later on, all variation is gone???
I Edit again same map file, add cycle to my buildings again and save again then this time its ok variation remains.
Looks like some program vaiable(s) are not initialized properly
When I open the map file with notepad after first save I found that last "character block" is missing.
It does finally appear on second save only.
I hope to be clear with my rough english
Rgds
Christophe
I notice an issue with "Terrain cycle" function on MAP Editor.
During Map Editing I use Terrain cycle to add variation on the map (eg to have different special building on adjascent hexes),Everything looks fine on display so far.
But after I saved the map and re open later on, all variation is gone???
I Edit again same map file, add cycle to my buildings again and save again then this time its ok variation remains.
Looks like some program vaiable(s) are not initialized properly
When I open the map file with notepad after first save I found that last "character block" is missing.
It does finally appear on second save only.
I hope to be clear with my rough english
Rgds
Christophe