Matrix Games Forums

[Deleted by Admins]

What was the game doing at the time?

[Deleted by Admins]

So clicked on a unit during turn resolution? Just updated? To version 2.0.10b or something else?

Thanks for the information.

[Deleted by Admins]

Can you please email me both of those saves so we can see what has happened. It sounds like a data corruption of some type has occurred. Thanks.

[Deleted by Admins]

Thanks. Yep work on supporting guidance repair and have an Aerospace degree. Hence rocket scientist. [:D]

I watched a space shuttle launch once...

close enough [:D]

Just purchased the game yesterday, updated to 2.0.10b and I am getting the same error message when playing through the Tutorial scenario. For me it occurs during Turn Resolution, without me clicking on any units.

[Deleted by Admins]

We are working on this and trying to get clues as to what might be triggering it. The screen shot at the top of this thread showed the problem happened partway while the focused unit was being moved into a new hex. It this is what happened to you or anyone else this would be very useful to localize the problem.

Thanks, Rob C

ORIGINAL: Sabreman1966

Just purchased the game yesterday, updated to 2.0.10b and I am getting the same error message when playing through the Tutorial scenario. For me it occurs during Turn Resolution, without me clicking on any units.

[Deleted by Admins]

ORIGINAL: RobertCrandall

We are working on this and trying to get clues as to what might be triggering it. The screen shot at the top of this thread showed the problem happened partway while the focused unit was being moved into a new hex. It this is what happened to you or anyone else this would be very useful to localize the problem.

Thanks, Rob C

For me it occurs when one of my units is firing. The first time it happened I clicked on OK to remove the message,the program then seemed to get stuck in a loop and just continually fire that one unit at the original target. The error message than continued to appear at regular intervals, everytime I clicked OK it would just resume the firing cycle of that one unit, until I had to reboot to get out of the program.

The second time it happened, I had loaded a save game (same game as above, but from near the start of the scenario)this time the error message popped up again when a unit was firing, again I closed it but no firing loop occurred, this time the phase just continued with nothing happening, no movement or firing from either side. The phase was due to last 14 minutes, but just carried on for over an hour with no sign of finishing, also the error message did not appear again. I could not pause the phase, so had to kill the program to get out of it.

Saberman, can you send that save file to look at?

Grognerd, Rob has your files and we both have been testing and looking for a common bug.

Thanks for the reports guys.

ORIGINAL: Capn Darwin

Saberman, can you send that save file to look at?

Grognerd, Rob has your files and we both have been testing and looking for a common bug.

Thanks for the reports guys.

Saves sent to OTS address, hope they help.

Same bug as the other players.
PC Windows 10. Downloaded game. Build 2.0.10b
Auto-save selected.
Scenario is eyes, ears and Teeth.
Save attached.
Messages appeared during the game resolution phase, units were moving to location, NSTR according to the game.
Error messages in the next post.

Error was duplicated on my laptop.
I unchecked the auto-save option, all went well but then the game "froze", nothing happeneing on the map (no movements/fire) and the clock is acting weird (time remaining is going down by the second and clock is increasing by the minute.

Cheers

Error messages.

Weird clock.
Time remaining until next order phase is decreasing by 1 sec, clock is increasing by 1 min. [&:]