Page 1 of 1
Is ground mapping radar supposed to show a sensor ring?
Posted: Fri Jul 08, 2016 6:16 pm
by ColonelMolerat
I'm playing Northern Inferno - Hunter or Hunted, and my RC-135W Rivet Joint has its AN/APQ-122(V) ground mapping radar active. However, there's no 'ring' on the map to show the radar's range (I have all of the range rings turned on to visible).
Is there supposed to be a range ring?
RE: Is ground mapping radar supposed to show a sensor ring?
Posted: Fri Jul 08, 2016 6:57 pm
by magi
hummm.....
RE: Is ground mapping radar supposed to show a sensor ring?
Posted: Fri Jul 08, 2016 7:22 pm
by Eggstor
As that particular radar is specifically a ground-mapping-only radar incapable of either air or surface search, I'd say the lack of a sensor range ring is proper.
RE: Is ground mapping radar supposed to show a sensor ring?
Posted: Fri Jul 08, 2016 7:41 pm
by ColonelMolerat
Hah, oops, that's why I asked! I wasn't sure whether ground-mapping meant it mapped things on the ground, or it mapped the ground itself... Is there any point to using it in CMANO?