Minor Bug with Port Construction
Posted: Wed Feb 26, 2003 9:41 pm
When building a Port at a base with an SPS of 0, the % completion is a little off.
The second digit is being cut off, for lack of a better word. Normally, the % completed is expressed as a two digit number.
In this case, it's a one digit number, dividing by 10 rather than 100.
So if you are 0-9% complete, it will say 0% complete.
10-19% complete, 1% complete.
20-29% complete, 2% complete.
And so on and so forth.
Like I said, a minor bug. Once I figured out what it was doing, I stopped being amazed that it took my engineers forever to get to 9% and then overnight they zoomed to 100%!
The second digit is being cut off, for lack of a better word. Normally, the % completed is expressed as a two digit number.
In this case, it's a one digit number, dividing by 10 rather than 100.
So if you are 0-9% complete, it will say 0% complete.
10-19% complete, 1% complete.
20-29% complete, 2% complete.
And so on and so forth.
Like I said, a minor bug. Once I figured out what it was doing, I stopped being amazed that it took my engineers forever to get to 9% and then overnight they zoomed to 100%!
