Page 1 of 1

What i am doing wrong?

Posted: Thu Oct 26, 2017 8:19 pm
by PaxxPrime
Greetings

i`m new to Command Modern Air / Naval Operations. I`ve done the tutorials and now i`m going for the Shifting Sands Missions...

First one went well but second one...

I am unable to drop bombs (GPB) on the targets.
My Aircrafts keep circling around the target at a given Altitude, think they maintaining the altitude i gave them before via "Throttle - Altidude/Depth" command to prevent them climbing up to 36000ft.
But i set them back to "auto" in the Unit Status Dialog.

Doesn`t matter if i tell them to auto-attack or manual attack... they keep circling and in some rare cases they drop their bombs but not on the first approach.

So what i`m doing wrong?
Please help me....
[&:][&:][&:]
best regards Chris
[&:][&:][&:]

RE: What i am doing wrong?

Posted: Thu Oct 26, 2017 8:43 pm
by Cik
shift-F1 and click the target, what is the reason you cannot launch weapons against it?

RE: What i am doing wrong?

Posted: Thu Oct 26, 2017 8:59 pm
by PaxxPrime
yes i tried to maual allocate weapons to target, reason given there is "out of range". But Aircrafts going to the target, they just not drop[&:]

RE: What i am doing wrong?

Posted: Thu Oct 26, 2017 11:19 pm
by Cik
post a save file

RE: What i am doing wrong?

Posted: Fri Oct 27, 2017 6:53 am
by PaxxPrime
atached[:)]

RE: What i am doing wrong?

Posted: Fri Oct 27, 2017 2:04 pm
by Schr75
Hi PaxxPrime

I can´t open your save. The scen file is corrupted. Please re-upload.

Regards.

Søren

RE: What i am doing wrong?

Posted: Mon Oct 30, 2017 12:48 am
by Rhygin00
Maybe they circle too close and they can't make an attack run. Move them away a little and try again...or check whether the aircraft is too low to drop bombs. You might also have doctrine or WRA settings which prohibit the drop.