Page 1 of 1
The counter values editor uses the wrong words
Posted: Sat Dec 02, 2017 6:56 am
by Fred98
When I click on the button marked, the words at the bottom of the screen do not reflect what I am seeing on the counter.
In the screen shot, the movement allowance of this unit is not zero!
.
.
.
RE: The counter values editor uses the wrong words
Posted: Sat Dec 02, 2017 8:26 am
by Oberst_Klink
Works fine here. Can you right-click/refresh the unit in the control panel?
Klink, Oberst
RE: The counter values editor uses the wrong words
Posted: Sat Dec 02, 2017 8:38 am
by Fred98
Note I highlighted some words at the bottom of the screen.
What does your screen show?
.
RE: The counter values editor uses the wrong words
Posted: Sat Dec 02, 2017 9:00 am
by JPJ
ORIGINAL: Fred98
Note I highlighted some words at the bottom of the screen.
The tooltip/Info Panel text for advanced counter values may be incorrect.
That has been reported in the Tech forum, for example see here
tm.asp?m=4390339
RE: The counter values editor uses the wrong words
Posted: Sat Dec 02, 2017 12:07 pm
by Curtis Lemay
ORIGINAL: Fred98
When I click on the button marked, the words at the bottom of the screen do not reflect what I am seeing on the counter.
In the screen shot, the movement allowance of this unit is not zero!
.
.
.
You must have clicked past the Movement Remaining display and are displaying Unit Timestamps. The timestamp of that unit is 0.
RE: The counter values editor uses the wrong words
Posted: Sat Dec 02, 2017 1:20 pm
by DanNeely
ORIGINAL: Curtis Lemay
ORIGINAL: Fred98
When I click on the button marked, the words at the bottom of the screen do not reflect what I am seeing on the counter.
In the screen shot, the movement allowance of this unit is not zero!
.
.
.
You must have clicked past the Movement Remaining display and are displaying Unit Timestamps. The timestamp of that unit is 0.
Which is one side of the bug he's reporting, the underlined text at the bottom of the screenshot says its showing movement allowances.
RE: The counter values editor uses the wrong words
Posted: Sat Dec 02, 2017 2:57 pm
by Meyer1
Yes it has been pointed and Ralph said that was a bug.
RE: The counter values editor uses the wrong words
Posted: Sat Dec 02, 2017 6:25 pm
by Fred98
Thanknyou. It is a known bug then.