Page 1 of 1
Screen shot seems to show 5 rounds and 8 rounds at the same time
Posted: Thu Jan 04, 2018 10:00 pm
by Fred98
I am still learning the game mechanics and was studying a feature.
I moved some troops forward and attacked a small unit. I moved, attacked and moved attacked a few times. The attacks were resolved automatically.
This did not use up any "rounds".
On the last time the attack was not resolved automatically. I had to push "Complete all battles" button.
This caused the "rounds" to jump to 5. In spite of that the screen shot shows that the battle took 1 round and I have used 8 rounds!
I don't understand!
.
.
RE: Screen shot seems to show 5 rounds and 8 rounds at the same time
Posted: Thu Jan 04, 2018 10:09 pm
by Meyer1
I guess that the combat lasted one round but started in round 7, perhaps because that unit attacked from an hex with a BTS. Or not, just that the combat started late because of other reasons. Checking the combat chart should clarify it.
RE: Screen shot seems to show 5 rounds and 8 rounds at the same time
Posted: Thu Jan 04, 2018 10:14 pm
by Meyer1
Keep in mind that when you make an enemy unit to "retreat before combat" (RBC, or what you meant by "resolved automatically") also leaves a BTS in that hex so if other of your units move through that hex or attack from there it will pay a penalty by the way of movement points/starting the attack in a later round.
RE: Screen shot seems to show 5 rounds and 8 rounds at the same time
Posted: Thu Jan 04, 2018 10:21 pm
by Meyer1
Oh, and the turn advancing to round 5 instead of round 8:
From the manual, 14.1:
This is a new feature that (hopefully) will finally resolve the issue to the enjoyment of everyone. Under TOAW IV, after all combats are resolved, the player-turn will advance to the combat round of the MEDIAN length combat. In other words, if there were seven combats that lasted 1, 1, 2, 2, 3, 3, & 6 rounds respectively then the player turn would advance only two rounds, instead of the six rounds of before. Note that this means that three combats lasted longer than the round of the new combat phase. This will be accounted for by placing a TIME STAMP in those three hexes that will equal their actual ending round.
RE: Screen shot seems to show 5 rounds and 8 rounds at the same time
Posted: Fri Jan 05, 2018 5:12 pm
by Oberst_Klink
It also could be the case, what Fred described, that the AD and/or MRPB weren't adjusted. Worth checking.
My suggestion for Crusader '41, which is 5km/hex and 1 day/turn scenario: AD=14 and MRPB=3. On top of that, I adjusted other thingies, basically using Bob's CFNA values; works fine now.
Supply distribution was an issue, but not as bad as being portrayed in some older TOAW I vanilla scenarios. Just my suggestion and out of experience...
2x-check it, Fred.
Klink, Oberst