Page 1 of 1

Final Fire Question

Posted: Sat Feb 24, 2018 2:40 am
by Gerry4321
Ami 747 in black-circled hex.

German HS moves (Pink arrow) and is pinned.
German Squad moves (purple line) and the 747 final fires. Thought it could only final fire at units that were as close as the nearest enemy unit - in other words only a firing range now of 2 hexes?

Thanks,

Gerry

Image

RE: Final Fire Question

Posted: Sat Feb 24, 2018 11:29 am
by genesismwt
From the manual:

First Fire:
A personnel unit that is not marked First/Final marker fires at full potential. Personnel units (Squad/HS/Crew) once they fire are marked with First Fire marker. If a weapon that has ROF fires and maintains ROF, it can fire again. A weapon that loses ROF cannot fire again.
Subsequent Fire:
A personnel unit that is marked with First Fire marker can fire again but at ½ of its fire power. Once the personnel unit fires, it is marked with Final Fire marker.
Final Fire:
A Personnel unit marked with Final Fire marker can only fire into adjacent hex; in addition the personnel unit marked with Final Fire marker has to perform morale check. If the personnel unit fails its morale check, it breaks (broken+ state).

Only Final Fire(FPF in ASL) has a range restriction. I am with you, and would like the addition Subsequent Fire being limited to the range of the closest known enemy unit.

Unless adding this rule will greatly slow the engine down while it checks every hex for an enemy unit. Then, in the interest of play-ability, I would say keep it as it is.



RE: Final Fire Question

Posted: Sat Feb 24, 2018 12:48 pm
by Peter Fisla
ORIGINAL: genesismwt

Unless adding this rule will greatly slow the engine down while it checks every hex for an enemy unit. Then, in the interest of play-ability, I would say keep it as it is.

Correct