Page 1 of 1

Best Method to Garner Correct Facing

Posted: Fri Mar 09, 2018 4:52 pm
by Oxybeles
Perhaps I'm just uncoordinated, but I struggle to get a unit to correct the correct hex side when moving one hex.

Is there something I'm missing that would easily correct this issue.

I hate struggling with such an interface issue.

RE: Best Method to Garner Correct Facing

Posted: Fri Mar 09, 2018 7:48 pm
by maitrebongo
Normally, when you move your mouse cursor over the hex adjacent to your unit, you should see an orange arrow, the tip of which indicates the direction to which your unit will point at the end of its movement.

If you bring your cursor closer to the edge of the hexagon corresponding to the direction you want, the tip of the arrow also changes direction ...
The best is that you try, after a while it becomes intuitive.