Matrix Games Forums

The manual says that you can both move and adust the size of an objective when using the battle generator using drag and drop.

I can't. Tried everything I can think of to grab an objective and move it. Same with the size (though you can use the objective radius + - buttons to make one smaller or larger - in rather large increments though).

Is the manual wrong or do I just not get it? Hopefully I just don't get it because I find the default locations chosen by the AI to be in most cases - well - kind'a strange.

In the battle generator screen if you click on an objective, it will disappear and then re-appear in a new location that you click. This way you can change the objective locations.

ORIGINAL: Issue8

In the battle generator screen if you click on an objective, it will disappear and then re-appear in a new location that you click. This way you can change the objective locations.

Ahhhh...
Nice. Thanks.

Another thing: you can adjust the size of the deployment areas if you click inside the green or red areas and slide the mouse, making the deployment areas wider or more narrow.

You also cannot place an objective over a feature containing water ie a bridge. So if you cannot place an objective where you want one especially if you want a scenario defending a bridge, it may be because there is a water feature in that location which will not allow you to do it..