Page 1 of 1

M3 Bradleys

Posted: Thu Nov 22, 2018 10:10 am
by kch
Hi. Just a quick question..

How would you use these on a defensive mention? Once they have detected the enemy columns, would you let them hang back and use the TOWs to take out T80s, or best to take them completely out of the firing line.

(I am playing around with the Time to Dance scenario)

RE: M3 Bradleys

Posted: Thu Nov 22, 2018 3:57 pm
by Stimpak
Once the column is initially detected, it should still be consistently observed to detect any changes in direction, behavior, or perhaps even the arrival of enemy reinforcements. Keeping enemy columns detected also increases the lethality of artillery strikes and your own accuracy in calling them in. One man with a radio can ruin an entire regiment's day, so keep your recon alive and doing its job. That being said, if the enemy is making a deliberate effort to engage or destroy your recon assets, then that is when they should withdraw.

RE: M3 Bradleys

Posted: Fri Nov 23, 2018 5:56 am
by kch
thanks... I will pull them out of danger, but still in positions to observe. I did try to place them on a reverse slope to take a few tanks passing through a valley, but that failed miserably.. They were slaughtered by the T80s.

Does the game use "facing"? I.e. are the units facing in a certain direction (even if it cant be seen on the counters) and can you ambush by attacking from the side or rear?

RE: M3 Bradleys

Posted: Sat Nov 24, 2018 1:35 am
by Stimpak
How far away were said T-80s? Never try to perform recon under 2km (4 hexes). Even 5-6 hexes is dicey.
Ambushes can be performed so long as the enemy initially doesn't detect your units when they start firing.

RE: M3 Bradleys

Posted: Mon Nov 26, 2018 6:29 am
by kch
I was definitely too close then. 500m iguals 1 hex right? I guess I continuously fall into the trap of using recon assets as combat units.

RE: M3 Bradleys

Posted: Mon Nov 26, 2018 6:25 pm
by Stimpak
500m is way too close - in daylight conditions not even smoke will cloak your units.