error at launch: "can't set screen mode"
Posted: Mon Dec 24, 2018 12:35 am
-Running a laptop with 1920x1080 native display screen. Tried changing the display to 1024x768. Same problem.
I *can* run it if I add a -w to the target line on the shortcut, but then it is a little box in the middle of my screen.
-The strange thing is, on my other laptop with 4k native display, it shows up great on the entire screen.
But I prefer to run it on this laptop, and I can't figure out why it won't work like it does on the other one.
Are there any other command switches I should try?
Any ideas? Thanks for any help!
I *can* run it if I add a -w to the target line on the shortcut, but then it is a little box in the middle of my screen.
-The strange thing is, on my other laptop with 4k native display, it shows up great on the entire screen.
But I prefer to run it on this laptop, and I can't figure out why it won't work like it does on the other one.
Are there any other command switches I should try?
Any ideas? Thanks for any help!