Page 1 of 1
Mouse Over Not Working In Combat Planning Window
Posted: Mon Jan 14, 2019 10:06 pm
by Icedawg
In TOAW III, when I planned an attack, I could mouse over units and get their names, now I cannot do this - no unit name pops up. Is there some setting that I need to change to get this function back? It seems odd that the devs would eliminate this very essential function. When planning attacks, I want to use particular artillery units to bombard, but now, I'm just selecting blind.
RE: Mouse Over Not Working In Combat Planning Window
Posted: Tue Jan 15, 2019 4:47 am
by nukkxx5058
I'm interested in this too ... was wondering the same.
RE: Mouse Over Not Working In Combat Planning Window
Posted: Tue Jan 15, 2019 2:10 pm
by Shadrach
Well it does show the current unit name in the bar at the bottom. But it would be much better if the Unit Panel on the right updated as we used the planner.
It would allow us to see crucial details to decide if a unit should be part of the combat or not, like health, strength, supply, readiness.
RE: Mouse Over Not Working In Combat Planning Window
Posted: Sun Jan 20, 2019 8:37 pm
by larryfulkerson
+1
RE: Mouse Over Not Working In Combat Planning Window
Posted: Mon Jan 21, 2019 5:01 pm
by Icedawg
Found the problem. Just had to adjust the resolution on my computer. After some trial and error, I now can see the names of all units in the attack planning window.