Page 1 of 1
Removing wrecks
Posted: Mon Feb 18, 2019 3:07 pm
by edward77
Started up with the new Middle East campaign. A bit rusty! Could you please tell me how and with what do you remove a wreck? Edward77.
RE: Removing wrecks
Posted: Mon Feb 18, 2019 3:26 pm
by Jason Petho
You can use an ARV.
RE: Removing wrecks
Posted: Tue Feb 19, 2019 10:21 am
by Crossroads
Hello edward77,
We've got a dedicated CS Middle East forum
HERE.
You might also find useful questions and tips posted there.
RE: Removing wrecks
Posted: Tue Feb 19, 2019 11:53 am
by edward77
Ok Thank you Jason.
RE: Removing wrecks
Posted: Tue Feb 19, 2019 12:28 pm
by Jason Petho
No problem!
RE: Removing wrecks
Posted: Fri Feb 22, 2019 9:14 am
by edward77
Jason, Further questions please.
1. Cannot get an adjacent AI Armoured Eng (Syrian)to remove mines from a heavy road bridge across an AT ditch. No message about failure or success to remove yet all action points have been used (perhaps trying to build a bridge?).
2. How do I get AI heavy tanks across an AT ditch. According to the editor manual (Engineering)an AVLB can only create light or medium bridges, although the associated picture appears to show a heavy bridge.
RE: Removing wrecks
Posted: Fri Feb 22, 2019 10:04 am
by Oberst_Klink
ORIGINAL: edward77
Jason, Further questions please.
1. Cannot get an adjacent AI Armoured Eng (Syrian)to remove mines from a heavy road bridge across an AT ditch. No message about failure or success to remove yet all action points have been used (perhaps trying to build a bridge?).
2. How do I get AI heavy tanks across an AT ditch. According to the editor manual (Engineering)an AVLB can only create light or medium bridges, although the associated picture appears to show a heavy bridge.
Hi Ed!
if possible, can you drop your questions in the
CSME Forum (here)? It makes it easier for the devs and the gamers to spot & answer them.
Klink, Oberst
RE: Removing wrecks
Posted: Fri Feb 22, 2019 1:50 pm
by Jason Petho
Jason, Further questions please.
1. Cannot get an adjacent AI Armoured Eng (Syrian)to remove mines from a heavy road bridge across an AT ditch. No message about failure or success to remove yet all action points have been used (perhaps trying to build a bridge?).
An engineer needs to be in the same hex as the mines in order for them to be cleared.
2. How do I get AI heavy tanks across an AT ditch. According to the editor manual (Engineering)an AVLB can only create light or medium bridges, although the associated picture appears to show a heavy bridge
I don't believe you can. AVLB generally only creates medium bridges.
On the same token, I don't think there are many tanks classified as heavy in CSME.