Page 1 of 1

question: unit blocked

Posted: Thu Nov 19, 2020 6:54 am
by sirecram
hello,
I started a game where I'm playing allies.
By mistake, I put a Naval Bomber (USA) reinforcement in Alaska (hex 274,34)

Now, this unit can move only 1 case per turn
I think this is due to poor supply and, as consequence, it has only 1 AP per turn.
Impossible to travel accross canada to join USA west coast.
Impossible to disband unit also.

I'm trying to move it to the nearest town/port but it's slow and I'm not sure it will be possible to embark it.
(I had same kind of pb with in SC WiE with a canadian unit...)

Am I missing something to "recover" this unit ?



RE: question: unit blocked

Posted: Thu Nov 19, 2020 11:38 am
by Hubert Cater
Yes unfortunately the unit is suffering from low supply effects. If you can get it back to Skagway or Prince Rupert where supply is higher then you should be able to 'Operate' the unit once again.

RE: question: unit blocked

Posted: Thu Nov 19, 2020 1:12 pm
by EarlyDoors
Training accident

RE: question: unit blocked

Posted: Fri Nov 20, 2020 4:52 am
by sirecram
thanks for your answer
I finally reached Skagway and was able to operate the unit

RE: question: unit blocked

Posted: Sat Nov 21, 2020 7:11 am
by OldCrowBalthazor
ORIGINAL: EarlyDoors

Training accident

LoL I did that in SC-WW1 by sending a UK Dirigible to a Scottish island before looking at its supply (which was 0). It looked like a great spot to watch over the North Channel (which would of been ok if it was upgraded). It stayed there entire war.