Page 1 of 1
[1.08.04b] attacking artillery capitulated
Posted: Sun Mar 28, 2021 8:51 am
by bvoid
As subject, was bombarding some enemies in adjacent hex - no counter-battery fire.
Did some damage, 1 kill - but at end of fight all my units capitulated? And it wasn't just a display bug - the units were GONE afterwards.
Had 2 independenty artillery units attacking, and 2 militia units.
Is this intended?
RE: [1.08.04b] attacking artillery capitulated
Posted: Sun Mar 28, 2021 3:46 pm
by newageofpower
Send save to Vic, with link to this thread in the email.
RE: [1.08.04b] attacking artillery capitulated
Posted: Mon Mar 29, 2021 5:36 am
by Vic
if you can repeat this behaviour from a save file send it to
vic@vrdesigns.net please. And tell me which unit i'll have to attack with which unit please.
i'll check out whats going on.
best wishes,
Vic
RE: [1.08.04b] attacking artillery capitulated
Posted: Wed Mar 31, 2021 5:57 am
by bvoid
Sorry I wasn't able to find the save, I played a bunch of games over the weekend
In lots of games this has only ever happened to me once.
RE: [1.08.04b] attacking artillery capitulated
Posted: Wed Mar 31, 2021 8:37 am
by zgrssd
I would guess this could happen if the units run out of ammo or supply on the last combat turn. Asuming of course Ammo consumption is calculated per turn.
All defending units should naturally capitulate, but the code might include ranged attack artillery as well.
RE: [1.08.04b] attacking artillery capitulated
Posted: Sat May 15, 2021 7:10 am
by BlueTemplar
I wonder if it could be related to :
5.10.15.1. Combat looP
[...]
Attackers always capitulate when combat round 30 has been reached. This
can happen on very rare occasions, like with the so called “rebel combat.”
?
RE: [1.08.04b] attacking artillery capitulated
Posted: Fri Oct 08, 2021 11:14 am
by Heahengel
Apologies for a thread necro. I found this because I had the same problem with a missile launcher unit. I luckily have a save where it is repeatable. Would that still be useful?
I did some quick testing and I'm pretty sure the issue is that I have too many units in the hex. I hadn't realized that there was a 16 unit cap before, but I can see that I cannot move an additional unit into the hex. However, I was allowed to raise a unit there which brought my total to 17 units in hex. The unit display in the bottom bar kind of cycles through the top 16 units as I select them rather than displaying all of them - it's functional. I tried taking a turn and they all survived. Interestingly, attacking with air units still works as expected. It's only my missile launcher that capitulates every time I attack with it, unless I move a unit off the hex first.
RE: [1.08.04b] attacking artillery capitulated
Posted: Mon Nov 15, 2021 12:50 pm
by Vic
Will be fixed next patch! thanks for reporting