Page 1 of 1
Just curious... why Axis Upkeep on turn 1?
Posted: Wed Apr 21, 2021 11:45 am
by willgamer
I thought that the forces started the game in basically pristine condition. However, the Germans, even if you do nothing, will experience production (non oil) upkeep for 3-4 turns, and the poor Italians for about a dozen turns. After these turns the production upkeep will return to zero.
What's being upkept?
RE: Just curious... why Axis Upkeep on turn 1?
Posted: Wed Apr 21, 2021 12:12 pm
by AlvaroSousa
If I remember some units are reduced in strength
RE: Just curious... why Axis Upkeep on turn 1?
Posted: Wed Apr 21, 2021 1:31 pm
by willgamer
According to the units report, there are no understrength German and 1 understrength Italian xx.
The only thing done on turn one is to increase the reinforce/upgrade to a big number.
Turn 2 shows Upkeep: German 67, Italian 29; and continues, per previous post, for several turns.
RE: Just curious... why Axis Upkeep on turn 1?
Posted: Wed Apr 21, 2021 2:36 pm
by AlvaroSousa
That is just how much is allocated. I set it to 50% of production at the start of the scenario. It doesn't mean it is spent.
RE: Just curious... why Axis Upkeep on turn 1?
Posted: Wed Apr 21, 2021 6:00 pm
by willgamer
I'm in failure to communicate mode...
Again, on turn one I increase the reinforce/upgrade higher than total production. I know that won't be spent if not needed. That's all that is done on turn one.
On turn two, without doing anything, just looking at the Build tab/Production I see that the Germans spent 67 on upkeep and the Italians 29.
I don't understand... the Germans upkeep should have been zero.
RE: Just curious... why Axis Upkeep on turn 1?
Posted: Wed Apr 21, 2021 6:31 pm
by AlvaroSousa
It is upgrades.
RE: Just curious... why Axis Upkeep on turn 1?
Posted: Wed Apr 21, 2021 6:40 pm
by willgamer
OK, I'll have to check that out... Thanks! [:)]