Matrix Games Forums

I'm sure everyone has noticed this one.

If you click on a map unit stack it will cycle through the units (the map icon changes). However if you click the box in the bottom-left to select a unit then it won't change the map icon. Thus you could have an aeroplane unit selected, and the map will show the correct range - but the map icon will show another unit.

I think the intended behavior is that the map should show the selected unit on top of stack.

This can add to UI confusion for new players, but everyone else is just used to it.

Hopefully an easy fix.

You *can* actually see the highlighted border moving from unit to unit on the map too, even with the "Smaller counters" map mode OFF.

This *might* be a good idea to "fix" - to have units getting automatically reordered when you select one of them (instead of having to click the selected unit again to re-order them), but this might interfere with the way that the "Smaller counters" map mode works ? (And changing unit display order can be confusing on its own...)

However, I also see some inconsistencies there :
- With the "Smaller counters" ON, clicking on a map icon of an already selected unit again does *not* re-order the units.
- With the "Smaller counters" ON, units seem to be ordered inversely compared to Units tab bottom left (from bottom right to top left - for the first 4 ones at least). (Or is this a workaround for when you have more than 16 units that end up stacked in a single hex, so some of them end up "invisible" in the Units tab ?)