Torpedo targeting
Posted: Tue Aug 24, 2021 11:30 am
Trying to work out torpedo use.
In Harpoon I wwould set an activation point at which the torpedo would go active and start homing in on the target, usually from a different bearing to the one I was on.
When I do a BOL launch in CMO I'm not sure if this sets an activation point, as the sensor arc shows immediately, and I finally worked out that after a BOL you have to use f1 on the target to get the torpedo to actually try to home in on it.
Am I doing something wrong here? Rather than selecting a target, I would expect the active sonar to guide the torpedo to whatever it detects.
Is there a better way to get a torpedo to go active to home in on a target from a direction that _doesnt_ show them exactly where I am?
Thanks
In Harpoon I wwould set an activation point at which the torpedo would go active and start homing in on the target, usually from a different bearing to the one I was on.
When I do a BOL launch in CMO I'm not sure if this sets an activation point, as the sensor arc shows immediately, and I finally worked out that after a BOL you have to use f1 on the target to get the torpedo to actually try to home in on it.
Am I doing something wrong here? Rather than selecting a target, I would expect the active sonar to guide the torpedo to whatever it detects.
Is there a better way to get a torpedo to go active to home in on a target from a direction that _doesnt_ show them exactly where I am?
Thanks