Matrix Games Forums

I observed this issue in all scenarios. Playing latest CMO update beta 1267.1 and latest Tacview 1.9.0Beta3.

Destroyed aircraft as well as fired missiles that did not hit aircraft targets remain suspended in the air, which makes the scene heavily cluttered.

Thank you.

hi fulcrum28, thanks for posting about this issue.
I see units remain visible in tacview only when Tacview does not refresh it's windows so when the scen is stopped right after a unit is destroyed or when no units remain on the scen.
I'm using Tacview 1.8.7.200.
When easy can you give a try with a non beta version of Tacview?
Also if you can attach your ExceptionLog I will have a look at it.
Thanks

Hi Deserere,

thanks for checking this. I reverted my Tacview from 1.9.03Beta to latest released version 1.8.8. Note that I use steam so I cannot use your version 1.8.7.2 because this is not the latest non beta version of Tacview and steam keeps updating to latest every time I start a game. If you could update CMO to the latest released version 1.8.8 of Tacview it would be great. Currently, TACVIEW is not playable with CMO 1267.1 Beta. I also attached a game save in PM.

Thank you.

Hi fulcrum28,
I'll have a look, avoid PMing any information that might be relevant for other devs that looks into the matter, feel free to attach the scenario here
Thanks

Andrea

Hello Andrea,

thanks a lot for checking this. I attach a save. But I observed this in all scenarios.

Thank you.

Hi fulcrum28, thanks for the details.
The issue should be fixed and will be in the next update release, let me know if any issue persists.

Thank you!

Hello, I installed the latest beta 1268.1 and using tacview 1.8.8 The problem remains. The exhausted missiles and destroyed aircraft still visible in scene. If you close the tacview and open it again, then they vanished ..etc.

Thank you in advance.

i still have the same problem too after installed the latest beta 1268.1. The exhausted missiles and destroyed aircraft still visible in scene and if you close the tacview and open it again, then they vanished.
i try both Tacview 1.8.8 & 1.9.0 beta3 and this problem remains.

same problem remains in 1277.1.

Logged #14834

I confirm that it is not working correctly either in version 1290.1. Tested with latest Tacview 1.9.05 Beta.
**Exhausted missiles and destroyed planes remain in the scene until at least you close and open again Tacview**
Thanks.

PS: As a side note I noticed that the Mig-23 in the Top Gun 1986 scenario uses now the correct 3D model instead of the default one, so it is good news, thanks a lot for fixing this.

I confirm that it is not working correctly either in version 1290.1. Tested with latest Tacview 1.9.05 Beta.
**Exhausted missiles and destroyed planes remain in the scene until at least you close and open again Tacview**
Thanks.

PS: As a side note I noticed that the Mig-23 in the Top Gun 1986 scenario uses now the correct 3D model instead of the default one, so it is good news, thanks a lot for fixing this.

This has been fixed for the next build.

Thanks a lot!