Matrix Games Forums

Help.

I'm working on a new scenario, and when I created a delta ini file, I got the message that there were errors in it. I opened up the log file and found this information, but I have limited experience with programming, so I am not sure what this means or how I am supposed to fix it. Any advice would be welcome. Thanks!

-----cut here-----

Scenario: Turbat Incursion, 2025
Scenario file: C:\Program Files (x86)\Matrix Games\Command Modern Operations\Scenarios\Turbat Incursion, 2025.scen.scen
Config file: C:\Program Files (x86)\Matrix Games\Command Modern Operations\Scenarios\Turbat Incursion, 2025.ini
WARNING: Sensor AN/SLQ-32(V)6 [ECM] [5753] to be added to unit DDG 98 Forrest Sherman (DDG 96 Bainbridge [Arleigh Burke Flight IIA] [2873]) belongs to a Sensor Group. The SBR cannot handle sensor groups and the sensor itself has been added to the INI file. Please change the sensor to the corresponding sensor group in the INI file manually.
WARNING: Sensor AN/SLQ-32(V)6 [ESM] [5754] to be added to unit DDG 98 Forrest Sherman (DDG 96 Bainbridge [Arleigh Burke Flight IIA] [2873]) belongs to a Sensor Group. The SBR cannot handle sensor groups and the sensor itself has been added to the INI file. Please change the sensor to the corresponding sensor group in the INI file manually.
WARNING: Sensor AN/SLQ-32(V)6 [ECM] [5753] to be added to unit DDG 98 Forrest Sherman (DDG 96 Bainbridge [Arleigh Burke Flight IIA] [2873]) belongs to a Sensor Group. The SBR cannot handle sensor groups and the sensor itself has been added to the INI file. Please change the sensor to the corresponding sensor group in the INI file manually.
WARNING: Sensor AN/SLQ-32(V)6 [ESM] [5754] to be added to unit DDG 98 Forrest Sherman (DDG 96 Bainbridge [Arleigh Burke Flight IIA] [2873]) belongs to a Sensor Group. The SBR cannot handle sensor groups and the sensor itself has been added to the INI file. Please change the sensor to the corresponding sensor group in the INI file manually.
Export Completed

I have gotten this too. I tried to add a DECM pod to a magazine and it said that.

I assume it means if the sensor is actually a group of sensors (in my case, the load out is a single pod but it contains multiple sensors) it won’t work in the INI file, whereas a simple radar pod would.

I don’t know if this is an actual error or not, because when I tried updating the DB for the scenario that had the issue, nothing appeared wrong- the sensor pods were there just fine.

Perhaps it might be a different issue for a sensor suite like the AN/SLQ-32 vs. an addon pod?

I have been getting that error in the ini files in recent updates. I have run a bunch of tests and so far the error doesn't seem to impact the execution of the scenario.

It's not really and error, it's a warning as it says, and in recent years I think perhaps a superfluous one, that you'll get when you customize units, particularly sensors added individually 99% of the time it should not be a problem, even if you have everything added that is part of a group, you'll still get the message - which you can ignore, never had a problem ...that I know of anyway, so I reserve the 1%.