Matrix Games Forums

Bought this game immediately after Talonsoft release (back when there were like 5 rubber factories!). I play on/off ever since, and so glad it is still being supported ... thanks everyone. Finished an allied BTR campaign just yesterday ... new challenge when my wayward Berlin night bombers kept threatening Switzerland . But I understand this was fixed.

Anyway, I updated to 1.06.66. Loaded up a new BTR axis full campaign. Went to Production Control ... switched to Human ... and I couldn't make any production changes. Is it just me?

It may be just you... you need to make sure the airframe you select is actually in production. If it's not, you need to display other production lines so that you can retool them to the aircraft you want to research.

My production control is allowing me changes again ... performing as I remember in the past. I am calling it user error unless I can recreate the problem. I was messing with DXwind at the same time while upgrading to the latest version, or possibly loaded up a game save from a previous version? <shoulder shrug>

I have the same problem - or I don't understand what I'm doing wrong.

I go to production (o) and then select an aircraft type with current production (Bf 109G-5, for example).
The production planner opens, where factories and products are displayed on the right. I can click on the factories (highlighted yellow now), but when I click on the product (Bf 109 parts for example) I can't change anything. Nothing happens.

Everything else in the game works fine.
Have I overlooked something? I am using the latest patch.
Thank you very much for your help.

(Production control is human of course)

Are you familiar with the "Production" instructions in the Manuals folder? That may help.

Are you committing the changes after adjusting the factory output?

Ah, I overlooked this file, I'll get on with it. So far I haven't been able to change anything, now I'm one step further and can try it out. Thank you very much, that was helpful.